Krystal High-Build Sealer wood finish from M.L. Campbell delivers better hang, better build and excellent edge hanging while eliminating sand-throughs when used on quality wood projects. Distributor Service Inc. worked with M.L. Campbell chemists and with its professional wood shop customer base to fine-tune Krystal High-Build Sealer to meet the needs of professional wood shops of all sizes.
KRYSTAL HIGH BUILD SEALER is a non-yellowing, HAP’s compliant, high solids acid catalyzed sealer with exceptional sag resistance. KRYSTAL HIGH BUILD SEALER will produce an easy sanding finish with very good durability and high resistance to water, solvents and chemicals. Pre-cut (no-fill) sandpaper must be used for sanding, 220 grit is recommended. KRYSTAL HIGH BUILD SEALER must be catalyzed 10% with C1491 M.L. Campbell Care Catalyst or 5% with C1431 Care Catalyst Low VOC added to unreduced product prior to use.
• More durable and moisture resistant than conventional nitrocellulose or vinyl sealers
• Non-yellowing and HAP’s compliant
• High resistance to water, solvents and chemicals
• Will produce an easy sanding finish
• High solids acid catalyzed sealer with great sag resistance
Using Krystal High-Build Sealer in a wood shop environment, when 5 wet mils are sprayed onto a stained wood panel, a wet film gauge can typically detect 5 wet mils to 6 wet mils on the piece. Even with 6 wet mils on the panel, Krystal High-Build Sealer delivers great hang with no sags or runs.
KRYSTAL HIGH BUILD SEALER may be used on any interior wood surface where a high performance, high solids, moisture, water and chemical resistant finishing system is needed. KRYSTAL HIGH BUILD SEALER is much more durable and moisture resistant than conventional nitrocellulose or vinyl sealers with added benefits of easy application, quick drying, high solids and build.
Reports are in from the field...Professional Wood Finishers love using M.L. Campbell's Krystal High-Build Sealer. They appreciate the time-saving advantage of only applying two coats to achieve high build, they like the products high sheen, which makes it easier to sand and they acknowledge the fact that the sealer provides high build on the edges.
Just one coat of Krystal High-Build Sealer delivers roughly 2 mils of coating weight, helping to prevent sand-through. Most competitor sealers can only provide 1 mil to 1.5 mils of coating weight. With this product, wood finishers gain 1 mil to 1.5 mils in coating weight. And, this wood sealer allows professional finishers to sand 15 minutes after spraying because it powders up well. Krystal High-Build Sealer also has a little bit of sheen to it, making it easier to sand.
M.L. Campbell recommends at least 3 mils of coating to give a professional piece proper protection. When one coat of M.L. Campbell's Klearvar finishing system is applied overtop just one coat of Krystal High-Build Sealer, a very high dry coating average of between 3.6 mils and 4.1 mils is achieved. To get this dry coating level with most competitor products, three coats need to be applied.
M.L. Campbell offers specialty finishes, touch-up products, additives, reducers, retarders and catalysts to meet all of your wood finishing needs.